0 6ghz Coaxial Lightning Arrester - China

JHLA-6BP is 0-6GHz coaxial lightning arrestor, it features low

VSWR, low insertion loss, freezing cold and withstand

multiple lightning, etc.

performance, CE compliant.

- Industry’s Best RF Performance

- Integrated Connector Cavity, Compact, Fully Weatherized

- Maintenance Free

- Multi-Strike Capability

- CE Compliant

性能ࡠ 2;数

Model JHLA-6BP

Frequency Range 0-6000MHz

Connector N-K - N-J

Insertion Loss <0.1 - 0.3 dB

VSWR ≤1.5

Discharge Voltage DC230V

Maximum Power 200 Watt

Impedance 50 Ω

Operating Temperature -20° C to +60° C

Dimension 68×31×23mm

Weight 130 g

1 - The JHLA-6BP Lighting Arrestors are designed to protect equipment from surge caused by lighting strikes on tower or in close proximity to antennas.

Lightning strikes are typically pulsed DC but there is also an RF component at about 2.2MHz.

The first pulse averages 18KA.

Subsequent pulses are usually about half that.

An average lightning strike consists of 3-4 pulses.

2 - Proper grounding of the antenna systems and tower are imperative to prevent equipment damage.

Antenna and equipment should be connected to a single point ground.

The best ground is a 3Ft or longer cropper rod driven into the soil.

Alternate grounds are (in order of decreasing effectiveness):

-Building Steel or rebar

-Cold Water Pipe

-Meter Building Skin

-Electrical System Ground

3 - Pole and tower grounding should utilize copper braid or strapping for maximum energy dispersion.

4 - Coax cable should be grounded at the antenna and where the cable leaves the tower or mounting pole.

If the antenna mounting pole is properly grounded, then the antenna and coax are grounded via the antenna mounting bracket system.

The coax should also be grounded as low as possible where the cable leaves the tower or mounting pole.

Grounding kits are readily available to ground the coax to a tower base or pole base.

5 - The JHLA-6BP comes in a 230V discharge model.

The discharge voltage is the threshold voltage at which the surge suppressor starts to dump energy to ground.

6 - The JHLA-6BP Lighting Arrestor should be located as close to the radio equipment as possible.

7 - Ground the JHLA-6BP Lighting Arrestor by using an AWG#8 wire and crimping or soldering to the wire lug included on the JHLA-6BP.

You can also use a larger wire (#6) and wrapping around the grounding screw.

The other side of the wire should be connected to a solid earth ground.

A solid earth ground can be a properly grounded tower or mounting pole.

The connection point for the ground wire from the JHLA-6BP should always be closer to the single point earth ground used than the radio equipment grounding location.

Another grounding method is to mount the JHLA-6BP to an enclosure, then the bulkhead N connector becomes the ground path.

8 - Waterproof all connections using a good waterproofing tape such as a self annealing rubber tape.

use an outer coating of high quality vinyl electrical tape.

Spiral wrap so overlaps act as shingles to shed the water.

9 - If mounted in-line, support the lightning arrestor by tightly tie wrapping to the tower or pole using UV resistant (black) tie wraps.

Company Contact:

• Posted By: Shanghai Jinghong Communication Technology Co., Lt

• Phone: 18721708527

• Address: Room 501, 9th Building, No.518 XinZhuan Road, Song, Shanghai , China

• Email:

• Business Description: Shanghai Jinghong Communication Technology Co., Ltd.